Connecteur LED 2 broches 10mm 5050 pour rubans LED - Sans soudure

Aquests connectors estan fabricats principalment en policarbonat (cos) i contactes interns de coure niquelat. La dimensió típica és de 16 mm × 13 mm × 6 mm per unitat, i admeten tires de 10 mm d’amplada específicament per a tires LED tipus 5050 de 2 pins.

No requereixen manteniment més enllà de verificar que no hi hagi brutícia ni pols als contactes en instal·lar-los o manipular-los. La seva vida útil depèn del nombre de cicles de connexió/desconnexió i pot superar les 500 insercions. El plàstic pot envellir si s’exposa a raigs UV o calor extrema, cosa que pot escurçar-ne la funcionalitat.

El connector suporta fins a 5 A a 24 V DC, adequat per a la majoria de tires LED 5050 estàndard. Superar aquest límit podria causar sobreescalfament o pèrdua de contacte. Es recomana calcular el consum total de la tira abans d’instal·lar-la.

These connectors are mainly made from polycarbonate (body) and nickel-plated copper internal contacts. The typical size is 16 mm × 13 mm × 6 mm per unit, and they accept 10 mm wide strips specifically for 2-pin 5050 LED strips.

They require no maintenance beyond checking that there is no dirt or dust on the contacts when installing or handling them. Their service life depends on the number of connect/disconnect cycles and can exceed 500 insertions. The plastic may age if exposed to UV rays or extreme heat, which can shorten its functionality.

The connector supports up to 5 A at 24 V DC, which is suitable for most standard 5050 LED strips. Exceeding this limit could cause overheating or loss of contact. It is recommended to calculate the strip’s total current draw before installation.

These connectors are mainly made of polycarbonate (body) and nickel-plated copper internal contacts. The typical size is 16 mm × 13 mm × 6 mm per unit, and they accept 10 mm wide strips specifically for 2-pin 5050 LED strips.

They require no maintenance beyond checking that there is no dirt or dust on the contacts when installing or handling them. Their service life depends on the number of connect/disconnect cycles and can exceed 500 insertions. The plastic may age if exposed to UV rays or extreme heat, which can shorten its functionality.

The connector supports up to 5 A at 24 V DC, which is suitable for most standard 5050 LED strips. Exceeding this limit could cause overheating or loss of contact. It is recommended to calculate the strip’s total current draw before installation.

Dessa kontakter är huvudsakligen tillverkade av polykarbonat (hölje) och invändiga kontakter i förnicklad koppar. Den typiska dimensionen är 16 mm × 13 mm × 6 mm per enhet, och de passar 10 mm breda remsor, specifikt för 2-poliga 5050 LED-remsor.