Haut-parleur Alcatel DB et DB View - Pièce de qualité pour votre téléphone

L’altaveu, generalment fabricat amb una carcassa plàstica i components interns de membrana metàl·lica i bobina de coure, té dimensions aproximades de 18 mm x 12 mm x 4 mm i un pes inferior a 10 g. La caixa inclou únicament el mòdul altaveu de reemplaçament, sense eines addicionals.

Sí, aquest altaveu normalment s’ha de soldar a la placa base del telèfon, per la qual cosa es recomana utilitzar un soldador de punta fina (10-30 W) i estany calibre 0,5 mm. No s’aconsella l’autoinstal·lació sense experiència prèvia en electrònica per evitar danys als terminals.

Aquest tipus de recanvi compleix els estàndards interns dels dispositius Alcatel quant a voltatge (1,5-3 V) i potència (<0,5 W), però no és aplicable a normatives externes com CE o RoHS individualment, ja que es ven com a component de reemplaçament específic.

A diferència de molts genèrics, aquest altaveu està fabricat sota especificacions equivalents a les originals, cosa que normalment es tradueix en un millor ajust físic, una durabilitat mitjana més alta (50000 cicles d’ús estimats) i una menor distorsió del so (THD <5% a 200-4000 Hz). Les versions genèriques poden presentar variacions en impedància i resposta de freqüència.

The speaker, generally made with a plastic housing and internal metal diaphragm and copper coil components, has approximate dimensions of 18 mm x 12 mm x 4 mm and weighs less than 10 g. The box includes only the replacement speaker module, with no additional tools.

Yes, this speaker normally has to be soldered to the phone's motherboard, so a fine-tip soldering iron (10-30 W) and 0.5 mm solder wire are recommended. Self-installation is not advised without prior electronics experience to avoid damage to the terminals.

This type of replacement complies with Alcatel's internal device standards in terms of voltage (1.5-3 V) and power (<0.5 W), but it is not individually subject to external regulations such as CE or RoHS, as it is sold as a specific replacement component.

Unlike many generic units, this speaker is manufactured to specifications equivalent to the originals, which usually results in a better physical fit, higher average durability (estimated 50,000 use cycles) and lower sound distortion (THD <5% at 200-4000 Hz). Generic versions may show variations in impedance and frequency response.

The speaker, generally made with a plastic housing and internal metal membrane and copper coil components, has approximate dimensions of 18 mm x 12 mm x 4 mm and a weight of less than 10 g. The box includes only the replacement speaker module, with no additional tools.

Yes, this speaker normally has to be soldered to the phone's motherboard, so it is recommended to use a fine-tip soldering iron (10-30 W) and 0.5 mm solder wire. Self-installation is not advised without prior electronics experience to avoid damage to the terminals.